Mobile: 082 494 5460  Email: info@crazy-pools.co.za

Dosing Instructions:

Before dosing POOLCURE make sure of the following:

  • Check that the filter is clean. Back wash two or three times before adding POOLCURE.
  • Check the pH of your pool. It should be lower than 7.5. POOLCURE performs at its best below 7.5 pH.
  • Ideal pH for your pool is 7.2
  • Check that the CREEPY is functioning 100%.

TIP!         If your filter sand is older than 2 years or very dirty, replace it. You will not be sorry.

IMPORTANT:

Pour POOLCURE into the weir - Never pour any chemical directly into swimming pool!

Check your pools pH for the first few days. Add pool acid if necessary.

 

Dosage Guidelines for POOLCURE.

In all cases below, ensure the pH level remains within the recommended levels of 7.0 to 7.2

1st time POOLCURE users are to use a double dose of POOLCURE in the 1st treatment.

 

The monthly estimated dosages of POOLCURE

25,000 litres = 400 ml

30,000 litres = 500 ml

50,000 litres = 1 litre

90,000 litres = 1.5 litres

120,000 litres = 2.5 litres

150,000 litres = 3 litres

300,000 litres = 6 litres

 

The level of copper should be approximatly 0.4 mg/l (ppm).  The maximum level of copper should not exceed 0.8 mg/l (ppm).

 

This table shows the approximate amount of POOLCURE required to raise the copper level by 0.1mg/l (ppm).

 

LITRES POOLCURE DOSE

25,000 litres = 50 ml

30,000 litres = 60 ml

50,000 litres = 120 ml

90,000 litres = 180 ml

120,000 litres = 240 ml

150,000 litres = 300 ml

300,000 litres = 600 ml

Contact Details

PIETER DE KOCK
Cell: 082 494 5460
Email: info@crazy-pools.co.za
Website: www.crazy-pools.co.za